Why Is My Raycon Case Blinking Green (2024)

FAQs

Why Is My Raycon Case Blinking Green? ›

CHARGING YOUR DEVICE

The AirPods case typically displays a static green light, which indicates a good charge. However, if the green light is flashing, it may mean that the case cannot detect one of the AirPods.

When Earbud is placed into the charging case, and the case is closed, there should be light indicators on the front of the case to show that the LEFT and RIGHT earbuds are charging. Check that both lights turn on.

Once fully charged, the LED will hold a Green light. When placing or removing the earbuds in the Capsule, the LED will blink Green.

The battery indicator lights indicate the charging status of your earbuds and charging case. The earbud battery indicator light is located inside of the charging case whereas the battery indicator light on the front of the charging case indicates the charging status of the case itself.

Quick green double blinks indicate that your Pod's connection is being optimized. This will happen immediately after setup and periodically overnight, but it can also be triggered by a change in your environment, such as increased interference.

The green LED under the REG. label indicates that the headphone is fully charged. This will take about 2-3 hours if completely drained of battery Flashing green light on the Volume Control ( VOL + and VOL -) indicates a medium volume has been reached.

When the remaining battery charge is low, the indicator lights on the headphones or the charging case will repeatedly and slowly flash orange for about 15 seconds. Set the headphones into the charging case and charge them using the supplied USB Type-C™ cable when this happens.

Make sure that earbud metal contacts are clean and there is no debris blocking the earbuds from making contact with the case. Your earbuds will not charge if the capsule is open. Make sure the case is securely closed. This may require you to slightly shift the case to ensure closure.

Yes, the Fitness Earbuds are built to withstand sweat and water with an impressive IPX7 rating. This means they can handle your most intense workouts and even rainy outdoor adventures.

What does the button on the Raycon case do? ›

If you need to reset the headphones, you can press the button located inside the case.

So in the manual it says that when the earbuds are charging in the case, that the LED on the earbuds light up according to whether its charging or charged.

CHARGING YOUR DEVICE

The complete charging time is approximately 2 hours.

From the HOME Menu, select “Controllers”. The approximate battery charge for the console and any connected controllers will be displayed within the Controllers screen.

If the case is blinking red and your earbuds do not charge means that the case does not have enough battery charge to both charge the earbuds and the internal battery.

A solid red light indicates that the device is charging. The red light will go out when it's completely charged. A solid green light indicates that the battery is fully charged.

Additionally, when you long press the switch "MFB" for 5 Seconds, the red and green light will flash alternately,it means the earphone are searching the bluetooth device. The green light will flash under the normal condition(flash every a few seconds) When bluetooth device connects successfully.

To fully charge the earbuds in the case you'll need an hour, while the case itself usually takes 2-3 hours to charge completely.